Setting Up; First Use; Fitting/Removing The Brush Head/Interdental Brush; Floss Attachment - Nevadent NSZB 3.7 B3 Instrucciones De Uso

Setting up

NOTE
► In damp rooms, especially in the vicinity of water (bath), the charger 5
must be set up so that it cannot accidentally fall into the water .
1) Place the charger 5 on a clean and level surface .
Ensure that the charger 5 cannot fall into water, such as into a bath or sink .

First use

NOTE
Before starting to use the appliance, check that it is in fault-free condition .
You must not use the appliance if it has any faults .
1) Insert the power plug into the socket .
2) Before the first use, clean the new brush head 1 / the interdental brush r /
the floss attachment e with clear water .
3) Open the lid 3 and place the replacement brush heads, the interdental
brush r and/or the floss attachment e into the brush holders 4 as
required . Close the lid 3 .
4) Place the handset on the charger 5 so that it slides onto the pin on the
base .
5) Allow the handset to charge for around 14–16 hours before using it for
the first time . The charge indicator 6 on the front of the handset lights up
red during the charging process .
6) Use the handset repeatedly without charging the battery until the perfor-
mance becomes noticeably weaker or the toothbrush stops working and
the charge indicator 6 flashes red . Then recharge the battery for 14 - 16
hours . When the appliance is fully charged, the charge indicator 6 lights
up green .
7) Charge and discharge the toothbrush completely 3 times . At that point, the
battery will have reached its full capacity .
8) You can now leave the handset on the charger 5 after every use, so as to
always have full power available .
Fitting/removing the brush head/interdental
brush/floss attachment
■ To remove the respective attachment pull it upwards and off the drive shaft 2 .
■ When fitting the attachment, ensure that the drive shaft 2 on the handset
slides precisely into the socket on the attachment .
Push the attachment down until it completely covers the drive shaft 2 .
NOTE
We recommend only using original attachments . You can order replacement
attachments at any time (see section "Ordering replacement parts") .
► You can also use the replacement brush heads of the model Oral B
Sonic Complete* for this appliance .
*Oral-B is a registered trademark of Procter & Gamble .
│ GB │ MT
■ 28
©
NSZB 3.7 B3