Engine; Lubrication; Changing Engine Oil; Air Filter - TRAPP 42L13G60x8A Manual De Instrucciones

Engine

Lubrication

Only use high-quality detergent oil
rated with API service classification SF-
SJ. Select oil SAE viscosity grade
according to your expected operating
temperature.
Note: Check your engine oil level
frequently to avoid possible engine
damage from running low on oil.
Change the oil after every 25 hours of
operation or at least
once a year if the tractor is not used
for 25 hours in one year. Check the
crankcase oil level before starting the
engine and after each eight (8) hours
of operation. Tighten oil fill
cap/dipstick securely each time you
check the oil level.

Changing engine oil

Establish temperature range expected
before oil change. All oil must meet
API service classification SG-SL.
✔
Be sure tractor is on level surface.
✔
Oil will drain more freely when
warm.
✔
Catch oil in a suitable container.
1. Remove oil fill cap/dipstick. Be
careful not to allow dirt to enter the
engine when changing oil.
2. Remove yellow cap from drain valve
and install the drain tube onto the
fitting.
All manuals and user guides at all-guides.com
3. Unlock drain valve by slightly pushing
4. To open, pull out on the drain valve.
5. After oil has drained completely, close
6. Remove the drain tube and replace the
7. Refill tank with oil through oil fill dipstick
8. Use oil fill dipstick for checking level. For

Air filter

Your engine will not run properly using a
dirty air filter. Clean more often when
working in very dusty places. See Engine
Manual.
inward and turning counterclockwise.
and lock the drain valve by pushing
inward and turning clockwise until the
pin is in the locked position as shown.
cap onto the drain valve.
tube. Do not overfill. For approximate
capacity see the "Product specifications"
section of this
precise reading, thread tank cap onto the
tube before removing the dipstick. Keep
oil at "Full" line on dipstick. Firmly
thread cap onto tube when finished.
103