•
Any fixed wiring outside the heater coming into contact or close proximity to the heater must be
protected by sleeving with a temperature rating of at least 90°c.
All cabling behind the appliance must take the shortest route to the edge of the heater.
•
•
Ensure that the power cable is not coiled. Shorten the power cable if possible and do not place excess
cable on the rear of the heater.
•
Electrical connections must not be made directly behind the heater regardless of ceiling-mounting
position.
•
The heater is not to be located immediately below a socket outlet in ceiling-mounted positions.
DO NOT
•
drill through the heater as this will cause irreparable damage and is also dangerous.
DO NOT
•
connect a heater that is damaged in any manner to the power network.
For mounting the Herschel panel, install in accordance with this installation guide. Herschel Infrared Ltd
cannot accept responsibility for damage, loss or injury caused by, or resulting from incorrectly installed
heaters. Herschel Infrared Ltd will not assume liability for consequential loss however caused.
OPERATION:
The heater must be controlled by a Herschel thermostat or equivalent.
MAINTENANCE AND REPAIR:
Please note it is possible the heater may discolour with use - this is caused by air born pollution and is not a
fault.
The heater is designed to last many years and incorporates several safety functions, but if the heater has
not been used or installed in adherence to these instructions, emits any noise, smells or reaches high
temperatures in excess of 100°c, discontinue using the heater and refer to your local Herschel dealer.
The Herschel panel must be installed, uninstalled, cleaned or transported only when cold.
CLEANING:
Before attempting to clean the panel, isolate the unit from the electrical supply and allow it to completely
cool down.
DO NOT
immerse the Herschel panel heater in water or splash water onto it.
Clean the heater with a damp cloth . When clean, dry the surfaces with a dry cloth.
DO NOT
apply abrasive materials, solvents or solvent wipes to the surface as this can cause irreparable
damage.
Wait until the unit is completely dry before use.
REPAIR:
DO NOT
attempt to repair or adjust any electrical or mechanical functions on this unit, doing so will void
your warranty. Repairs must only be carried out by an authorised Herschel service partner.
DISPOSAL:
The heater is an electrical product.Waste electrical products should not be disposed of with
household waste. The heater has been designed to have as many recyclable components as
possible. Please recycle responsibly.
ENGLISH