Herschel HS350C Instrucciones De Instalación Y Funcionamiento página 5

ENGLISH
COMPLIANCE WITH ECODESIGN DIRECTIVE 2009/125/EC:
All Herschel Select Ceiling Tile Heaters when used with Herschel controllers demonstrate best-in-class
performance by exceeding EcoDesign (Lot 20) requirements for fixed electric room heaters.
Select Ceiling Tile heaters are not intended for free-standing (portable) use.
Herschel is not responsible for any breach of the legislation where the Select Ceiling Heater is used without
the appropriate Herschel controller.
See Appendix 1 for full details.
WARRANTY:
Register your product here:
https://www.herschel-infrared.com/customer-service/warranty-registration/
Within five years from date of purchase Herschel will repair or replace the heater where the fault is due to
defects in materials or workmanship. This warranty is for standard domestic use only and excludes
commercial uses. In the event of a warranty claim please visit the Customer Service area of the Herschel
Website and follow the Warranty Claim process. You will need proof of purchase and photographs of the
heater. A prerequisite for validity of the warranty is use at the specified supply voltage of the heater and
use in accordance with the conditions specified in this manual. Any further warranty or claims are excluded.
The warranty covers the repair or replacement of the defective product only and Herschel shall have no
liability for installation costs or consequential loses however incurred. The decision to repair or replace will
rest solely with Herschel and any replacement will be as close as possible in specification to the failed heater.
Removing the serial number will void the warranty. The warranty will also be void if the heater has been
tampered with or opened in any way.
The product power label must be left on the panels where they can be accessed after installation if
necessary. Herschel Infrared Ltd will assume no responsibility for scratches on surface or frames after first
use. Herschel Infrared Ltd cannot accept responsibility for damage, loss or injury caused by ingress of water
or moisture, accidental damage, mishandling, external impact, adjustment by unauthorised personnel or
failure to follow the correct maintenance and safety precautions as stated in the manual. Refer to Herschel
Infrared Ltd's warranty policy for full details. See https://www.herschel-infrared.com.
Note your serial number for future reference:
Installation Guide for Herschel Select Ceiling Tile Heaters
Placement in ceiling grid
Place the heater in an open 60 x 60 cm square in the ceiling grid.
DO NOT
use glues or other bonding agent to fix the panel in place.
Power cable must exit the back of the panel via the shortest possible route for attachment to mains.
DO NOT
under any circumstances coil or leave excess wire behind the panel.