Important Safety Precautions - Herschel HS350C Instrucciones De Instalación Y Funcionamiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28

IMPORTANT SAFETY PRECAUTIONS

READ THESE INSTRUCTIONS CAREFULLY AND RETAIN FOR FUTURE
REFERENCE.
Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1.
This appliance must be disconnected from its power source during installation or service activities and
when replacing.
2.
The Select Ceiling Tile Heater is not equipped with an integrated device to control the room
temperature. If intended for use in an enclosed space for the purposes of room heating, Herschel or
similar temperature controls must be used. If you do not use a room temperature controller,
use for room heating when rooms are occupied by people incapable of leaving the room on their own,
unless constant supervision is provided. Herschel is not responsible for any breach of EcoDesign (Lot
20) or Safety legislation where the heaters are used in an enclosed space without use of a Herschel
controller.
3.
In order to avoid overheating and potential fire hazard,
material or similar material under any circumstances.
flammable materials (eg. Furniture, curtains).
DO NOT
4.
touch the heater when in use. Herschel panel heaters have a surface temperature of around
95°C / 248°F and prolonged contact with the heater will cause burns and injury.
DO NOT
5.
operate the heater if the cord is damaged or after the heater malfunctions, or if it has been
dropped or damaged in any manner. Check each heater for damage before installation. Make sure that
the heater and the cable are free of any visible signs of damage. If the cord is damaged the appliance
must be sent for repair to an authorised Herschel Dealer.
6.
This heater must only be used for the heating of people or buildings. The heater is not to be used by
children or persons with reduced physical, sensory or mental capabilities, or lack of experience or
knowledge. Children should be kept away and should not be left unsupervised around the unit.
7.
All operators should only switch on/off the appliance provided that it has been placed or installed in
its intended operating position in accordance with these instructions. Children must not plug in, switch
on or regulate the appliance or perform user maintenance including cleaning.
IMPORTANT:
8.
Hz AC. If your supply voltage exceeds 240 Volts do not use the heater and refer to your local dealer.
IMPORTANT:
9.
SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION: IPX4
Herschel Select Ceiling Tile Heater panels are rated IPX4 enabling them to be located within splashable zones
in a bathroom (called Zones 1 & 2) which means they can be placed in the splash zone above a sink or bath.
However, installation in potentially wet or humid rooms such as bathrooms must be carried out by a suitably
qualified installer and comply with local electrical safety requirements. Installation must be such that:
the heater must not be able to become detached from the fittings and fall into a bathtub, shower,
swimming pool or other water container;
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50
The heater must be mounted on a non-flammable surface.
DO NOT
cover the heater with insulating
DO NOT
locate the heater within 0.3m of any
ENGLISH
DO NOT
Tabla de contenido
loading

Tabla de contenido