User Maintenance; Technical Information - Herschel COLORADO 2500R Manual Del Usuario

Safety & Energy-saving protection:
If a heater with remote control is left switched on continuously for a week (168 hours), the heater
•
will automatically switch itself off and must be restarted.
• Heaters with remote controllers are equipped with an overheat switch which will cut power to
the heater if it senses an overheat in the electronics. Please let the heater cool down for 15
minutes before attempting to restart.

USER MAINTENANCE:

The heater may be wiped-down with a soft damp cloth. Do not use abrasive detergents to clean the unit. In
marine environments, the unit may be gently sprayed clean with clean water with the POWER TURNED OFF
and completely cool. After cleaning, it is advisable to warm the heater for 10 – 20 minutes to dry the unit
and prevent staining.
The lamp used in the Herschel Colorado is Ultra long life (up to 10,000 hours). Changing the lamp should
only be carried out by suitably qualified personnel using the instructions available on Herschel's website.
TROUBLESHOOTING:
E1 Error on Display:
L1,2,3,4 shows in display, but no heat:

TECHNICAL INFORMATION:

Rated Power:
Heating Element:
Reflector:
Dimensions:
Remote control:
Warm-up time:
Useful wavelength range:
Weight:
Warranty:
Protection:
Control unit overheat. Check installation clearances.
Let heater cool for 15 minutes and restart heater.
Lamp is damaged. Arrange for replacement lamp with your
Herschel Dealer.
2500W at 220-240V
Ultra long life Carbon heating lamp (up to 10,000 hours)
Mirror Aluminium (98% reflection preventing rearward heat
loss)
879 x 195.3 x 84.7 mm
4 power levels (25% power increments) & 0-24 hour timer
(24 x 1 hour increments)
5-10 seconds
2 - 5μm
3kg
2 Years (excludes lamp & remote control)
IP55
ENGLISH