Philips RESPIRONICS SimplyGo Manual De Usuario página 23

SimplyGo User Manual
i
Tem
4
5
6
7
3� Press the Power button a second time to place the device in operating
mode� This second press helps prevent unwanted starts or inadvertent
changes in oxygen flow� The Introductory screen momentarily appears,
shown at left below, followed by the final operating mode screen, shown
at right�
Every time it starts up, the device starts producing oxygen to meet
the specified setting� It may take up to twenty minutes to reach the
specified purity levels for the setting� It is safe to begin breathing from the
SimplyGo device immediately� Breathing from the device will cause it to
reach oxygen purity levels faster�
The dot in the lower right corner of the LCD display is the pulse symbol� It
appears whenever the device delivers a pulse of oxygen�
Note: When it is turned on, the device will automatically start at the flow rate
setting used when the device was last turned off� As a precaution, each
time you start the device, verify the flow setting�
4� To set the device's flow setting, press either the + or – button�
To increase the flow setting, press the + button� To decrease the flow
setting, press the – button�
The device can be set to 1, 1�5, 2, 2�5, 3, 3�5, 4, 4�5, 5, 5�5, and 6 in Pulse or
Sleep Mode� It can be set to �5, 1, 1�5, and 2 in Continuous Flow Mode�
20
d
eSCriPTion
Amount of full charge currently in the battery�
External power is connected�
Software version in the device�
Indicates the allowable modes configuration
of the device� Note: This may not display on all
devices� This is normal�