Operating The Simplygo Device And Changing Device Settings - Philips RESPIRONICS SimplyGo Manual De Usuario

Operating the SimplyGo Device and Changing
Device Settings
You can change all device settings using the buttons on the control panel�
This includes starting the device, stopping it, silencing an alarm, and changing
oxygen flow�
The alarm system should be verified before use by the equipment provider
and between users by service personnel in accordance with the SimplyGo
service manual� However, the user may verify the functionality of the alarm
system as described below�
To start your SimplyGo device, follow these steps.
1� Connect a nasal cannula to the patient cannula connector on top of the
device, as shown� Ensure that the cannula is routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen flow�
Note: A standard single lumen nasal cannula and
tubing (not supplied) should be used to
deliver oxygen from the SimplyGo device�
The device works with cannula tubing
up to 30 ft� (9 m)� Only Continuous Flow
mode should be used for cannula lengths
greater than 7 ft� The proper placement and
positioning of the nasal cannula in the nose
is critical to the consistent operation of the SimplyGo�
2� To start the device, press the Power button� After the first press, the
display screen and the 5 button backlights turn on and you will see a
screen similar to the one shown below�
i
Tem
1
2
3
1
2
7
6
d
eSCriPTion
Push Power again to turn the device on�
Total number of operating hours for the device�
Indicates if the battery is being charged�
SimplyGo User Manual
3
4
5
19