Measuring Blood Pressure - Beurer medical BM 57 Instrucciones De Uso

The hours flash on the display.
• Select the current hours using the M1/
M2 memory buttons and confirm with the
START/STOP button
The minutes flash on the display.
• Select the current minutes using the M1/
M2 memory buttons and confirm with the
START/STOP button
The Bluetooth symbol flashes on the display.
®
• Use the M1/M2 memory buttons to select whether
automatic Bluetooth
tooth symbol flashes) or deactivated (Bluetooth
®
symbol is not shown) and confirm with the START/
STOP button .
Bluetooth transfers will reduce the battery life.
®
Operation with the mains part
You can also operate this device with a mains part. When do-
ing so, there must not be any batteries in the battery compart-
ment. The mains part can be obtained from specialist retailers
or from the service address using order number 071.51.
• To prevent possible damage to the device, the blood pres-
sure monitor must only be used with the mains part de-
scribed here.
• Insert the mains part into the connection provided for this
purpose on the right-hand side of the blood pressure mon-
itor. The mains part must only be connected to the mains
voltage that is specified on the type plate.
.
.
data transfer is activated (Blue-
®
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it from
the blood pressure monitor. As soon as you unplug the
mains part, the blood pressure monitor loses the date and
time setting but the saved measured values are retained.

5. Measuring blood pressure

Ensure the device is at room temperature before measuring.
The measurement can be performed on the left or right arm.
Attaching the cuff
®
Place the cuff on to the bare left upper
arm. The circulation of the arm must
not be hindered by tight clothing or
similar.
The cuff must be placed on the upper
arm so that the bottom edge is
positioned 2 – 3 cm above the elbow
and over the artery. The line should
point to the centre of the palm.
Now tighten the free end of the cuff,
but
make sure that it is not too tight
around the arm and close the hook-
and-loop fastener. The cuff should be
fastened so that two fingers fit under the cuff.
24