Service Information - Stanley STEL365 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

METALCUTTING (FIG. G)
f Use a finer blade for ferrous metals and a coarse
blade for non-ferrous materials.
f In thin gauge sheet metals it is best to clamp wood
to the underside of the sheet. This will ensure a clean
cut without excess vibration or tearing of metal.
f Avoid forcing cutting blade as this reduces blade life
and causes costly blade breakage.
Note: Spread a thin film of oil or other coolant along the
line ahead of the saw cut for easier operation and longer
blade life.
POCKET CUTTING-WOODONLY (FIG.H)
f Measure the surface area to be cut and mark clearly
with a pencil, chalk or scriber.
f Insert blade in blade clamp and tighten blade clamp
securely.
f Tip the saw backward until the back edge of the shoe
is resting on the work surface and the fully extended
moving blade will clear the surface.
f Grip unit with both hands, switch motor on permitting
blade to obtain maximum speed.
f Begin a slow, deliberate upward swing with the main
handle of the saw.
f The blade will begin to feed into material. Always
be sure blade is completely through material before
continuing with pocket cut.
Note: In areas where blade visibility is limited, use the
edge of the shoe as a guide.
PROJECT TIPS
f Cut only with sharp blades; they cut cleaner, faster
and put less strain on the motor while cutting.
f When cutting, always ensure that the shoe is held
firmly against the workpiece and the workpiece is
secured from moving/deflecting. This will improve
operator control and minimize vibration.
f For longer blade life, use bi-metal blades. These
utilize a carbon steel back welded to high speed steel
teeth making the blade more flexible and less prone to
breaking.
ACCESSORIES
This saw will accept up to a 12 inch long blade. Always
use the shortest blade suitable for your project but long
enough to keep the blade cutting through the material.
Longer blades are more likely to be bent or damaged
during use. During operation some longer blades may
vibrate or shake if the saw is not kept in contact with the
workpiece.
Warning! Since accessories, other than those offered
by Stanley, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only Stanley recommended
accessories should be used with this product.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

SERVICE INFORMATION

Black & Decker offers a full network of company-owned and
authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service centers
and if you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location
nearest you, or visit us at www.BlackandDecker-la.com
ENGLISH • 11
Tabla de contenido
loading

Tabla de contenido