Switching On/Off - Oase Bitron Eco 120W Instrucciones De Uso

- EN -
Operation
Control system overview
1 Operating mode
Four operating modes for irradiation of algae and germs as required ( Selecting the operating mode)
 LEDs indicate the selected operating mode.
 LED is lit blue: UVC lamps are switched on.
 LED is lit green: UVC lamps are switched off.
2 Button Functions
 For switching the unit on/off ( Switching on/off)
 For selecting the operating mode ( Selecting the operating mode)
 For reading the residual operating life of the UVC lamps ( Resetting the operating hour counter)
 For resetting the operating hour counter ( Resetting the operating hour counter)
3 UVC lamp sta- LED bars for indicating the residual operating life:
 Four LEDs lit: 9001 ... 12000 hours
tus display
 Three LEDs lit: 6001 ... 9000 hours
 Two LEDs lit: 3001 ... 6000 hours
 One LED lit: 1 ... 3000 hours
 One LED flashing: Replace UVC lamps.
 All LEDs unlit: At least one UVC lamp is defective.
4 Display Display of the operating status:
 Display of the current water temperature in °C
 Display of the system messages ( System messages)
 Display of the residual operating life of the UVC lamps ( Resetting the operating hour counter)

Switching ON/OFF

Function
Switching on
Switching off
28
Proceed as follows
Press .
Press several times until the UVC lamps
switch off after operating mode "100 %".
Note
 The operating mode "50 %" is active.
 The display indicates the current water temperature.
 The status display of the UVC lamps is lit.
 Switching sequence: 50 % – 75 % – 90 % – 100 % – Off.
 The display indicates OF.
 In the event of an error, the respective error message is indi-
cated in the display.
BTN0007