Submerged Installation Of The Pump; Commissioning/Start-Up; Switching On/Off - Oase AquaMax Eco Premium 4000 Puesta En Marcha

NOTE
If the pump is used for conveying excessively soiled water, the impeller unit will be subject to in-
creased wear and will require earlier replacement.
 Thoroughly clean the pond or pool before installing the pump.
 Install the pump at a raised level above the bottom of the pond. This reduces intake of muddy
water.

Avoid direct sunlight on unit components that are not submerged, as they may overheat. If
necessary, use a protective cover.

Submerged installation of the pump

Connecting
Connect the pump according to the desired installation variant.
 B
Do not plug the power plug into the socket yet!
Installation
 C
• Place the pump horizontally on a stable, mud-free surface.
• Ensure secure and stable positioning of the pump.
• Only operate the pump when it is fully submerged.

The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.

Commissioning/start-up

NOTE
Prevent the pump from running dry. Otherwise the pump will be destroyed.
 Only operate the pump when it is submerged or flooded.

Switching ON/OFF

• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.
Environmental Function Control (EFC)
When started up, the pump automatically performs a pre-programmed self-test (Environmental
Function Control (EFC)). The pump detects if it is running dry / blocked or submerged. The pump
shuts down automatically after 60 to 120 seconds if it runs dry/is blocked. In the event of a mal-
function, disconnect the power supply and "flood the pump" or remove the obstacle. Afterwards,
the unit can be restarted.
14