Bosch 3KLIFTTABLE Instrucciones De Operación página 10

Directional Locks and Rolling Brakes
Each caster on the Mobil Lift has a directional lock to
convert them from a swivel to a rigid caster. Pull on the
ring and rotate 90 degrees and release back into the
groove. Rolling brakes are located on the hub of the
caster wheels. Depress the "ON" portion to engage brakes
and "OFF" to release brakes. Engage all four brakes
before applying a load to the lift or when leaving the lift
unattended. See Figure 9.
WARNING: To prevent personal injury
and/or equipment damage,
● Always lock all four brakes before applying a load
to the lift or when leaving the lift unattended.
Adjustable Handle and Pump Position
If the load extends beyond the platform it may be necessary to extend the pump supports and the push
handle to avoid the load from obstructing the use of the handle or the pump. Ensure that all 4 of the
supplied screws are engaged through the preset adjustment holes in both the handle and base frame at
all times. Torque handle and pump support screws to 15 ft lb (20 N•m). See Figures 10 and 11.
WARNING: To prevent personal injury and/or equipment damage,
● Use the provided holes and all supplied screws to secure handle and pump supports.
Tightening mounting screws against tubing exterior may crush it.
● Ensure the load does not extend beyond the platform so far as to collide with the push handle
and/or pump.
Page 10 of 20
SP04513059 Rev A
MOBILE LIFT FEATURES
Figure 10
Mounting Screws
Frame Brackets
© Bosch Automotive Service Solutions Inc.
(continued)
Rolling
Brakes
Figure 9
3-Position Adjustable Push Handle
(To extend handle securely use all 4 mounting
screws–two holes on each side of handle.)
Base Frame
Figure 11
Adjustable Pump Support Rails
(Insert both mounting screws in the
provided holes of the support rails and
frame brackets to extend the pump.)
Directional
Locks
(shown in
swivel position)
1 2 3
(Handle Positions)