Fireplace Installation - Dimplex DF2010-EU Manual Del Proprietário

IMPORTANT SAFETY INSTRUCTIONS
WARNING: In order to avoid
overheating, do not cover the
heater

Fireplace Installation

!
NOTE: A 13 Amp, 230 Volt
alternating current (VAC) circuit is
required. A dedicated circuit is
preferred but not essential in all
cases. A dedicated circuit will be
required if, after installation, the
circuit breaker trips or fuse blows
on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk of
fire, electric shock or injury to
persons.
6
CAUTION: In order to avoid
a hazard due to the inadvertent
resetting of the thermal cutout,
this appliance must not be
supplied through an external
switching device, such as a timer,
or connected to a circuit that is
regularly switched on and off by
the utility.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
!
IMPORTANT: If not using
a Dimplex mantel, the fireplace
must be installed in an enclosure
with the following MINIMUM
Dimensions (Figure 2).
New Wall Construction
1. Select a suitable location that is
not susceptible to moisture and
www.dimplex.com