Battery Replacement - Dimplex DF2010-EU Manual Del Proprietário

Operation
Main Three Position ON/OFF
Switch to OFF and waiting 5
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and contact your
local dealer.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
Remote Control (Figure 5)
The fireplace is supplied with an
integrated on/off remote control.
Where the maximum rage of use
is ~15m.
WARNING: It takes time for
the receiver to respond to the
transimitter. Do not press the
buttons more than once within
two seconds for correct operation.
!
NOTE: Ensure that the
fireplace 3 position switch
is set to the remote control
setting (up position).
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace

Battery Replacement

To replace the battery:
1. Slide battery cover open
on the back of the remote
control.
2. Install AAA batteries into the
remote control.
3. Replace the battery cover.
Discard leaky batteries. Dispose
of batteries in the proper manner
according to provincial and local
regulations. Any battery may leak
electrolyte if mixed with a different
battery type, if inserted incorrectly,
if all the batteries are not replaced
at the same time, if disposed of in
a fire, or if an attempt is make to
charge a battery not intended to
be recharged.
Figure 5
off.
9