Fireplace Installation - Dimplex DF2608-EU Manual Del Usuario

Fireplace Installation

WARNING: Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the pow-
er cord is stored or secured to
avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
Figure 3
229
mm
585
mm
680 mm
always use a licensed electri-
cian.
Install the fireplace assembly into
the mantel (refer to mantel as-
sembly instructions).
!
NOTE: A 10 Amp, 240 Volt
circuit is required. A dedicated
circuit is preferred but not es-
sential in all cases. A dedi-
cated circuit will be required
if after installation the circuit
breaker trips or fuse blows
on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating
of the circuit breaker.
!
IMPORTANT: If not using a
Dimplex mantel, the fireplace
must be installed in an enclo-
sure with the following MINI-
MUM dimensions(Figure 3).
New Wall Construction
1. Select a suitable location that
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
2. Place the fireplace in the
desired location to see how it
will look in the room.
3. Mark the desired location on
the floor.
7