Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Stay behind the product.
3. Adjust the throttle control.
a) If the engine is cold, set the throttle control to the
choke position. (Fig. 44)
b) If the engine is warm, do not set the throttle
control to the choke position.
4. Hold the starter rope handle with your right hand.
5. Slowly pull out the starter rope until you feel some
resistance.
6. Pull with force to start the engine.
7. Set the throttle control to full throttle.
8. Release the start inhibitor.
9. Push the blade brake control in the direction of the
handlebar to start the blades.
To use the drive on the wheels
•
Pull the drive bail in the direction of the handlebar.
(Fig. 45)
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance
Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the blade brake control *
Examine the muffler *
14
•
Adjust the drive speed with the speed control on the
left side of the handle. Move the speed control
forward to increase the speed and rearward to
decrease the speed. (Fig. 46)
•
Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
•
Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
•
To stop the drive only, release the drive bail.
•
To stop the engine, move the throttle control to the
stop position.
To get a good result
•
Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
•
Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
•
Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 11 .
CAUTION: Make sure that the air filter is up
and not against the ground when you tilt the
product. Risk of engine damage.
Daily
Weekly
X
X
X
X
X
X
X
1500 - 001 - 02.07.2020
Monthly
Capítulos
Tabla de contenido
