Battery Charging Status; To Start The Product; To Use The Save ™ Function; High Load Function - Husqvarna LC 137i Manual De Usuario

6. Remove the battery from the battery charger.

Battery charging status

A Husqvarna Li-ion battery can be charged or used at all
charging levels. The battery is not damaged. A fully
charged battery will not decrease its charge when the
battery is left in the charger.
LED display
LED 1 flashes
LED 1 is lit, LED 2 flashes 25%-50%
LED 1, LED 2 are lit, LED
3 flashes
LED 1, LED 2, LED 3 are
lit, LED 4 flashes
LED 1, LED 2, LED 3,
LED 4 are lit

To start the product

1. Open the battery lid.
2. Put a charged battery in the battery holder.
3. Turn the safety key to 1.
4. Stay behind the product.
5. Loosen the start inhibitor.
1574 - 007 - 15.12.2021
Charging status
0%-25%
50%-75%
75%-100%
Fully charged
6. Push the motor brake handle in the direction of the
handlebar.
To use the SavE
The product has a battery saving function (SavE
gives longer operation time.
™
• Push the SavE button to position 1 to start the
function.
™
• Push the SavE button to position 0 to stop the
function.
Note:
™
The SavE function stops automatically if the
ground conditions make it necessary to have a higher
™
output. The SavE function starts automatically again
when the ground conditions let it.

High load function

When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.

Automatic restart

During operation, the blade and motor can temporarily
stop because of obstacles such as grass blockage
below the cutting cover. If this occurs and you keep the
motor brake handle pushed down, the product tries to
restart automatically. If the product does not restart in 5
seconds, it can be necessary to clean below the cutting
To clean the product on page 15 .
cover. Refer to
™
function
™
) that
13