Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SM 1619X07542 08-12_SM 1619X07542 08-12.qxp 8/27
Do not drill, fasten or break into existing
walls or other blind areas where electrical
wiring may exist.
unavoidable, disconnect all fuses or circuit
breakers feeding this worksite.
Battery tools are always in an operative
condition. Be aware of the possible hazards.
Always wear safety goggles or eye
protection when using this tool.
Secure the workpiece, never hold it in your
hand or across legs. The drilling action may
cause
you
workpiece and injury may occur.
WARNING
second bit may eject forcefully when the Sliding
Switch is pushed to the forward position.
When installing a bit, insert the shank of the bit
well within the collet. If the bit is not inserted
deep enough, the grip of the collet over the bit is
reduced and the loss of control is increased.
Do not run the tool while carrying it at your
side. A spinning bit could become entangled
with clothing and injury may result.
Do not use dull or damaged bits and
accessories. Dull or damaged bits have a
greater tendency to bind in the workpiece.
WARNING
If this situation is
to
lose
control
Do not insert two bits into a
single Bit Magazine slot. The
Some dust created by
power sanding, sawing,
8
of
the
Tabla de contenido
