Tabla de contenido
SM 2610005400 10-09:SM 2610005400 10-09.qxp 12/2/09 7:55 AM Page 70
maintenance and
lubrication
W RNING
misplacing of internal wires and components which could
cause serious hazard. We recommend that all tool service be
performed by a Skil Factory Service Center or Authorized Skil
Service Station.
Carbon Brushes
The brushes and commutator in your tool have been
engineered for many hours of dependable service. To
maintain peak efficiency of the motor, we recommend every
two to six months the brushes be examined. Only genuine Skil
replacement brushes specially designed for your tool should
be used.
W RNING
or performing any maintenance. The tool may be cleaned
most effectively with compressed dry air. Always wear safety
goggles when cleaning tools with compressed air.
Ventilation openings and switch levers must be kept clean and
free of foreign matter. Do not attempt to clean by inserting
pointed objects through openings.
Develop a regular check to make sure the lower guard is
working properly. Clean the lower guard of any sawdust build
up with a damp cloth.
Sawdust will accumulate:
•
Under the work table
•
Under the base
•
In the dust chute
•
Between the chip deflector and the blade
•
In the upper blade guard
•
On laser unit
C UTION
gasoline, carbon tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain ammonia.
Service
Preventive maintenance performed by
unauthorized personnel may result in
Cleaning
To avoid accidents always disconnect the
tool from the power supply before cleaning
Certain cleaning agents and solvents
damage plastic parts. Some of these are:
70
Capítulos
Tabla de contenido
