Assembly Of The Front Wheels; Folding The Chassis; Removing The Back Wheels; Removing The Front Wheels - Emmaljunga NXT 30 Manual De Instrucciones

Chassis

(3) Assembly of the Front Wheels

3.1 Press in the button on the front section of the pram and push in the front wheel. Release the button and check
that the front wheel is attached to the chassis properly by pulling the wheel. Repeat on both sides.
3.2 This is how the chassis should look when fully assembled. (as illustrated in the picture).

(4) Folding the Chassis

4.1 Turn the chassis so that the front wheels are pointing forward (as illustrated in the picture).
Make sure that the shopping basket is empty before folding the chassis.
WARNING There must not be a child in the pram when it is folded or unfolded.
WARNING Avoid having children in the vicinity when the pram is folded or unfolded.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
4.2 Push the grey button and fold the frontbar
4.3 Push the hood together
4.4 Pull up the grey handle to fold the backrest
4.5 Fold the backrest forward
4.6 Open both clips on the telescopic handle.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
4.7 Push the telescopic handle down to the lowest point
4.8 Slide the grey safety button to the middle (with the left hand) and simultaneously press the grey button under
the handle (with the right hand) and move to the center.
Hold the left safety button and the right handle and lift up a little bit.
4.9 You can now release the left hand and lift the handle up to fold the pram.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
4.10 Adjust the handle in the low position.
WARNING Ensure that children are kept away from all moving parts of the pram to avoid risk of injury.
4.11 The pram is now folded.
4.12 The chassis is locked with the grey clip. (as illustrated)
If you want to make the chassis more compact, you can remove the wheels. This can be done both before or
after you fold the chassis.

(5) Removing the Back Wheels

5.1 Release the shafts and wheel by, (1) press down the grey button and at the same time (2) open the grey clip.
Loosen the shaft by pressing the button on the rear wheel and pull out the shaft.

(6) Removing the Front Wheels

6.1 Press the grey button on the front part of the chassis and pull the front wheel off.

(7) Locking the Brake

7.1 Stop the pram by pressing the brake pedal all the way with your foot.
WARNING Never leave the child unattended in the pram without engaging the brake
WARNING The brake should always be applied when you lift your child in or out of the pram.
WARNING Never park the pram on a slope.
WARNING Always check that the pram is properly parked.

(8) Release the Brake

8.1 Release the brake by lifting the brake bar upwards with your foot.
8.2 If the pram is equipped with a safety leash:
Insert your hand into the leash for safety.
32
NXT 30 v 1.7