Troubleshooting - KitchenAid 5KSB7068 Manual Del Usuario

TROUBLESHOOTING

Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
1. When the Blender is plugged in
I/O
and the (main power On/Off)
toggle switch is set to
Blender will go into Standby mode
(flashing white indicator light). However,
after 10 minutes of no activity the
Blender will go into Sleep mode and
the indicator light will turn off.
• To wake up the Blender, simply flip
the (Start/Stop) toggle switch up
or down. This will put the Blender
back into Standby mode.
2. If the status indicator light flashes
an orange colour, the Blender is in
error mode. This can be caused by
using a spatula in the blender jar that
locks up the blade or having an ice
cube or hard food in a location that
locks up the blade.
• Correct the problem by turning off
the Blender using the main power
switch in the back, or by unplugging
the Blender. Remove the blender jar
from the base, and clear the items.
Place the blender jar back on the
base, and then turn the Blender
back on to continue regular use.
18 | TROUBLESHOOTING
W11036251B.indb 18
3. If the Blender stops while blending:
4. If the ingredients of a recipe aren't
I (
on), the
5. If you experience an overflow from
If the problem cannot be corrected, see
the "Warranty and service" section. Do not
return the Blender to the retailer; retailers
do not provide service.
• After 6 minutes of run time, the
Blender will automatically shut off
and go into Sleep mode, and the
LED light will turn off. You can wake
the Blender back up using the
toggle switches (Start/Stop) or
(Pulse High/Pulse Low). If the Blender
stops in less than 6 minutes, it is
possible there is an internal error with
the Blender. Contact an authorised
service centre for assistance.
blending:
• There may be times when an air
pocket is created around the blade,
causing the ingredients to miss the
blending blade. Use your Flex Edge
tamper to assist during the blend by
pushing ingredients into the blade,
or stir to move ingredients around
the blender jar. If that does not work,
stop the Blender, remove the blender
jar from the base, and use a spatula
to rearrange ingredients in the
blender jar. For certain recipes,
try adding more liquid.
the blender jar:
• Unplug the Blender. Remove the
jar and jar pad. Clean the blender
housing, jar pad, and exterior
of the jar. Dry each part thoroughly,
and then reinstall the jar pad.
• If the overflow is on or over the
control dial, it can be removed
by gently and firmly pulling it off.
After cleaning and drying, reinstall
the knob. To avoid damage to the
graphics, do not apply too much
force or use abrasive cleansers.
11/28/2018 2:19:51 PM