Lavorwash MARSHALL 2300 Manual Del Usuario página 17

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
7. Push the choke lever to the OFF position OFF (Fig. 11).
Chock lever
NOTE: Do not the choke if the engine is warm or
the air temperature is high.
8. Start the engine.
a) Push the engine switch to the ON position (Fig. 12).
b) Pull slightly the starting rope handle up until feeing
anti-action, and then make a rapid pull. (Fig. 13).
ON - Engine switch
Starting rope handle
CAUTION: Return the starting rope handle gently to
prevent damage to the starter.
9. Preheat the engine and push back the choke lever to
"OPEN" (Fig.14).
Chock lever
fi g. 11
CAUTION: Do not allow pressure washer to idle for
more than 2 minutes without switching off . Failure
to do this could cause appliance to the malfunction.
II. STOP
In an emergency, push the engine switch to "OFF" to
stall the engine. Stop it in normal in the following se-
quence:
fi g. 12
1. Push the engine switch to the OFF position (Fig. 15).
CAUTION: Turn off the machine when fi nished work-
ing.
CAUTION: When the machine is switched off , always
discharge the pressure hose, opening the gun.
MAINTENANCE
CAUTION: Before to carry out any kind of mainte-
fi g. 13
nance to the washer machine, run the pressure down,
take the water connection out.
I. LUBRICATION
Motor: see "owner's manual - general gasoline engine".
High-pressure water pump: we recommend GEAR
SYNTHETIC OIL ISO 150 - Oil capacity 60 gr.
OFF - Engine switch
fi g. 14
fi g. 15
17
Tabla de contenido
loading

Este manual también es adecuado para:

P86.0584

Tabla de contenido