The operation manual must be reviewed.
Never dispose of electrical equipment together
with household waste.
This machine conforms to the CE declarations.
For indoor use only.
Attention! Hot surface may cause burns.
PLEASE NOTE! Drawings in this manual are for
illustration purposes only and in some details it may
differ from the actual machine.
The original operation manual is in German. Other
language versions are translations from German.
USER MANUAL
SAFETY INSTRUCTIONS
General safety information for the use of electrical devices
To avoid injury from fire or electric shock, please ensure
the compliance with the safety instructions when using this
device. Please read the instructions carefully and make sure
that you have understood them well. Keep the manual near
the equipment to be able to read it at any time. Always
use current sources which are connected to the ground and
which provide the necessary voltage (this info is indicated
on the label on the device). If you have any doubts, let an
electrician check that your outlet is properly grounded.
Never use a damaged power cable. Do not open the unit
in damp or wet environment, or if your hands or body are
damped or wet. Protect the unit from solar radiation. Use
the device in a protected location to avoid damaging the
equipment or endangering others. Make sure the device is
able to cool and avoid placing it too close to other devices
that produce heat. Before cleaning the device, disconnect it
from the power source. Use a soft damp cloth for cleaning.
Avoid using detergents and make sure that no liquid enters
the unit. No internal element of this device needs to be
maintained by the user. Opening the device without our
approval leads to a loss of warranty!
SAFETY GUIDELINES
1.
Please read and understand these instructions
carefully before operating the device! Please observe
the safety guidelines carefully in order to prevent
damages through improper use!
2.
Please keep this manual available for future
reference. If this device is passed on to third parties,
the manual must be passed on with it.
3.
Only use this device indoors and for its intended use.
4.
We do not offer any warranty for damages resulting
from improper use or incorrect operation.
5.
Before the first use, check whether the main voltage
type and current comply with the indicated data on
the type plate.
6.
This device is not intended to be used by persons
(including children) with limited physical, sensory or
mental aptitude, as well as lack of experience and/or
knowledge, unless they are supervised by a person
responsible for their safety or if they have received
instructions as to how the device is used.
7.
ELECTRIC SHOCK HAZARD! Do not attempt to repair
the unit yourself. In case of device failures, repairs
must be done by qualified experts.
6
U S E R M A N U A L
8.
Please check the main plug and the power cable
regularly. If the power cable for this device is
damaged, it has to be replaced by the manufacturer
or its customer service or another qualified person in
order to prevent hazards.
9.
Prevent damages to the power cable by avoiding
squeezing or bending it or rubbing it on sharp
edges. Also keep the power cable away from hot
surfaces and open flames.
10.
ATTENTION! DANGER TO LIFE! While cleaning, never
immerse the device in water or other liquids.
11.
Under no circumstances should the housing be
opened.
TECHNICAL DATA
Product name
ELECTRIC FRYER
Model
RCEF 15E
RCEF 15D
Rated voltage [V]
230~
Frequency [Hz]
50
Rated power [kW]
3
2 x 3
Capacity [l]
17
2 x 17
Oil quantity [l]
11
2 x 11
Max. temperature
200
range [°C]
Weight [kg]
8
13
SCOPE OF APPLICATION
The fryer is exclusively designed to fry food.
Do not use the fryer to:
•
heat other substances or objects;
•
warm up liquids containing sugar, sweeteners, acids,
bases or alcohols;
•
warm or warm up flammable, noxious, particularly
volatile, or any other toxic substances.
The user is liable for any damage resulting from
nonintended use of the device.
BEFORE THE FIRST USE
Upon receipt of the goods, check the packaging for
integrity and open it. If the packaging is damaged, please
contact your transport company and distributor within 3
days, and document the damages as detailed as possible.
Do not turn the package upside down! When transporting
the package, please ensure that it is kept horizontal and
stable.
DISPOSAL OF THE PACKAGING
Please keep all packaging materials (cardboard, plastic
tapes and Styrofoam), so that in case of a problem, the
device can be sent back to the service centre in accurate
condition!
INSTALLING THE APPLIANCE
APPLIANCE LOCATION
The temperature of the environment must not exceed 45°C
and the relative humidity should not exceed 85%. Ensure
good ventilation in the room in which the device is used.
Rev. 03.11.2017
The distance between the back of the chain toaster and
the wall should be at least 20 cm, a minimum distance
between the sides of the device and the walls should be
at least 10 cm on each side and 35 cm between the top
of the device and the ceiling. Keep the device away from
hot surfaces. Operate the device on flat, stable, clean,
refractory and dry surfaces out of the reach of children and
people with mental disabilities. Install the device making
sure that constant access to the main plug is ensured. The
power cord connected to the appliance must be properly
grounded and correspond to the technical details. Before
the first use, remove all elements and clean them along
with the entire device.
PRINCIPLE OF OPERATION
4
5
7
6
3
2
8
1
1.
tap with release valve
2.
handle with basket
3.
lid
4.
thermostat
5.
power light
6.
thermostat light
7.
RESET button
8.
power cable
1.
Fill the tanks with oil so that level is between the
marks of minimum and maximum level.
2.
Set the thermostat to „0" and insert the plug into
an electricity socket. The green light will come on.
Then select the required temperature (in a clockwise
direction); the orange light will come on and the
heating element will begin heating up. Once the
required temperature has been reached, the heating
orange light will go off. The thermostat will maintain
the required temperature by automatically switching
the heating element on and off. This maintains the
required temperature and saves electricity. You may
begin frying.
3.
Use the baskets after mounting the handles. Place
food in the basket and immerse it into the oil. When
the food is tried, hang the basket up on the nail to let
the oil drop off.
4.
The covers are designed to keep the content warm
and t protect it from dirt. If you want to use the
covers, make sure they are not wet.
5.
When you have finished working, tilt the heating
elements 90 degrees backwards. The heating
elements are vertical, and the oil can drop off.
6.
Our fryers are equipped with a safety buton.
When the heating element is tilted back, it turns
automatically to prevent from accidents.
Rev. 03.11.2017
7.
Once the oil cools down to room temperature,
discharge it using the release valve.
8.
Make sure the thermostat is back to „0" (adjust
the thermostat knob anticlockwise) when you have
finished your work and disconnect the fryer.
9.
It is recommended to use only liquid oil or fat in the
fryer to avoid damages of the temperature limiter. It is
not recommended to put block fat in the fryer – block
fat should be melted before putting it into the fryer.
ATTENTION! The device has a sensor to prevent it from
overheating. If the device overheats when in use it will
automatically switch off. Then wait approx. 15 minutes,
unscrew the cap which protects the reset button, press
RESET and screw the protective cap back on. The device
may be used again.
ATTACHING THE HANDLE TO THE BASKET
TRANSPORTATION AND STORAGE
During transport, the machine should be protected from
shaking, falling and turning upside down. Store it in
a properly ventilated place with dry air and without any
corrosive gas.
CLEANING AND MAINTENANCE
•
Always unplug the device before cleaning it and after
each use.
•
Discharge oil and remove heating element.
•
Use a damp cloth suitable for cleaning devices or use
natural vinegar suitable for food grade equipment.
•
Do not use water to wash the electric control panel
as this might cause damage and invalidate the
warranty.
•
Use cleaner without corrosive substances to clean
surface.
•
After cleaning the device, all parts should be dried
before reusing it.
•
Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
CHECK REGULARLY THE DEVICE
Regularly check the machine for signs of damage. If the
machine is damaged, please stop using it immediately and
contact your customer service to solve the problem. What
to do in case of a problem? Please contact your customer
service and prepare the following information:
•
Invoice number and serial number (the latter is to be
found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or
defective part.
•
It will be easier for your customer service clerk to
determine the source of the problem if you give
a detailed and precise description of the matter. The
more detailed your information, the better customer
service will be able to solve your problem rapidly and
efficiently!
CAUTION: Never open the device without the authorization
of your customer service. This can lead to a loss of warranty!
7