Using The Controls; Temperature Adjustment - KitchenAid KRFC704FBS Manual Del Usuario

The Temperature Control UI is located above the external
dispenser and on the side of the left refrigerator door.
Viewing and Adjusting Temperature Set Points
For your convenience, your refrigerator and freezer controls are
preset at the factory.
When you first install your refrigerator, make sure that the
controls are still set to the recommended set points. The factory
recommended set points are 37°F (3°C) for the refrigerator and
0°F (-18°C) for the freezer.
IMPORTANT:
Wait 24 hours before you put food into the refrigerator. If you
■
add food before the refrigerator has cooled completely, your
food may spoil.
NOTE: Adjusting the set points to a colder-than-
recommended setting will not cool the compartments any
faster.
If the temperature is too warm or too cold in the refrigerator
■
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The recommended settings should be correct for normal
■
household use. The controls are set correctly when milk or
juice is as cold as you like and when ice cream is firm.
NOTE: Areas such as a garage, basement, or porch may have
higher humidity or extreme temperatures. You may need to
adjust the temperature away from the recommended settings
to accommodate for these conditions.
Wait at least 24 hours between adjustments. Recheck the
■
temperatures before other adjustments are made.
20

Using the Controls

View Temperature Set Points
1. Touch [—]/[+] for Refrigerator or [—]/[+] for Freezer and toggle
through temperature set points.
NOTE: To view temperature in degrees Celsius, touch and
hold the [°F/°C] button for 3 seconds and the temperature
display will change. To return to Fahrenheit, touch and hold
the [°F/°C] for 3 seconds and the temperature display will
change.
To activate Temperature mode for Drawer, touch DRAWER
and toggle through 4 optional temperature settings: Meats •
Fish, Cold Drinks, Deli • Cheese, and Wine. The display will
show the temperature set point of the selected setting for
the Drawer.
Recommended Refrigerator Temperature
Adjust Temperature Set Points
Refrigerator set point range: 33°F to 45°F (1°C to 7°C)
Freezer set point range: -6°F to 5°F (-22°C to -15°C)
1. Touch [—]/[+] to adjust the Refrigerator zone. The display will
show the temperature set point of the selected compartment
as shown.
2. When the temperature in is the range of Extend Freeze, the
display will light up. Extend Freeze is activated at the coldest
Freezer set point.
CONDITION:
REFRIGERATOR too cold
REFRIGERATOR too warm
FREEZER too cold
FREEZER too warm/
too little ice
Extend Freeze
This feature acts on the most-relevant storage parameters that
shall be controlled to minimize moisture migration from frozen
food. This in turn reduces the freezer burn occurrence.
To turn on the Extend Freeze feature, toggle to the coldest
Freezer temperature set point.
To turn off the Extend Freeze feature, toggle from the coldest
freezer set point to any other temperature.
Recommended Freezer Temperature
When adjusting temperature set points,
use the following chart as a guide:

TEMPERATURE ADJUSTMENT:

REFRIGERATOR setting 1° higher
REFRIGERATOR setting 1° lower
FREEZER setting 1° higher
FREEZER setting 1° lower