Using The Controls; Adjusting Controls - KitchenAid KRFC302ESS Instrucciones Para El Usuario

2. Replace the wine rack by inserting the left-hand side into its
bracket. Press inward on the right-hand side until it will slide
past the bracket edge and set it into its bracket.

Using the Controls

The control center is located at the top front of the refrigerator
compartment.
Temperature Controls
For your convenience, your temperature controls are preset at
the factory. When you first install your refrigerator, make sure the
controls are still set to the recommended set points as shown.
Recommended Settings
IMPORTANT:
The recommended settings should be correct for normal
■
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
When the power is on, the temperature display shows the
■
actual temperature of the compartment.
Wait 24 hours for your refrigerator to cool completely before
■
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
If the temperature is too warm or too cold in the refrigerator
■
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
Cooling On/Off:
Cooling On/Off turns off cooling for both compartments. It
■
does not disconnect power to the refrigerator.
Press and hold COOLING ON/OFF for 3 seconds. The LED
■
will light up to indicate that cooling is Off. Press the button
again to turn on the cooling. The LED will turn off.

Adjusting Controls

The REFRIGERATOR control adjusts the refrigerator compartment
temperature. The FREEZER control adjusts the freezer
compartment temperature.
If you need to adjust the temperature in either the refrigerator
or freezer compartment, use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The first touch of the (+) or (-) touch pad displays the current
temperature set point.
Press the (+) or (-) touch pads until the desired
■
temperature set point is displayed.
NOTE: Except when first turning on the refrigerator, do not
adjust either temperature control more than one setting at a
time. Wait 24 hours between adjustments for the temperature
to stabilize.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little
ice
REFRIGERATOR too cold
FREEZER too cold
Additional Control Center Features
Humidity Control
The Humidity Control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments or
when you notice moisture on the door hinge seal. The refrigerator
uses more energy when Humidity Control is on.
Press HUMIDITY CONTROL when the environment is warm
■
and more humid, or if you notice moisture on the door hinge
seal. The indicator light will be lit when humidity control is ON.
Press HUMIDITY CONTROL again to turn OFF and save
■
energy when the environment is less humid.
Sabbath Mode
The Sabbath Mode is designed for those whose religious
observances require turning off the lights and dispensers.
ON - All interior lights and alarm tones will be disabled.
OFF - All interior lights and alarm tones will be enabled.
Press and hold the SABBATH MODE touch pad for 3 seconds
■
or until the indicator light is lit to turn on this feature. Press
and hold the SABBATH MODE touch pad again to turn off this
feature.
Door Alarm
The Door Alarm feature sounds a chime every few seconds when
the refrigerator door has been left open for 5 continuous minutes.
ADJUSTMENT:
REFRIGERATOR Control 1°
lower
Adjust FREEZER Control 1°
lower
Adjust REFRIGERATOR
Control 1° higher
Adjust FREEZER Control 1°
higher
9