Wear Parts - Oase AquaMax Eco Titanium 3000 Instrucciones De Uso

- EN -
Replacing the impeller unit
N O T E
The impeller unit is guided in the motor block by a bearing. This bearing is a wear part and should be changed at the
same time as the impeller unit.
• Changing the bearing requires specialist knowledge and tools. Have the bearing changed by your OASE specialist
dealer or send the pump to OASE.
N O T E
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron filings).
• All particles must be removed from the impeller unit before reassembly. Any remaining particles can cause irrepara-
ble damage to the impeller unit and motor block.
Prerequisite:
• The pipes at the inlet and outlet are removed.
• Protection against injury: The protection caps are fitted to the inlet and outlet.
AquaMax Eco Titanium 30000
How to proceed:
 Q
1. Remove both screws from the EGC box on the pump base in order to hinge the box to the side.
2. Undo the screw at the base of the pump but do not unscrew it completely, then pull off the pump.
3. Remove the four screws and take off the pump casing.
4. Pull out the impeller unit and replace if necessary.
– Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
5. Place the pump casing onto the motor and fasten with the four screws.
6. Push the pump onto the pump base and tighten the screw.
7. Hinge the EGC box underneath the pump base and fasten with both screws.
AquaMax Eco Titanium 50000
How to proceed:
 R
1. Remove the screws and remove the pump from the stand.
2. Remove the four screws and take off the pump casing.
3. Pull out the impeller unit and replace if necessary.
– Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
4. Reassemble the unit in the reverse order.

Wear parts

The following components are wear parts and are excluded from the warranty:
• Impeller unit
• Bearing in the motor block
28