Remedy Of Faults; Maintenance And Cleaning - Oase AquaMax Eco Titanium 3000 Instrucciones De Uso

Remedy of faults

Malfunction
Pump does not start
Pump does not deliver.
Insufficient delivered quantity
Pump switches off after a short running period.

Maintenance and cleaning

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Cleaning the unit
N O T E
Recommendation regarding cleaning:
• Clean the unit as required but at least twice a year.
• When cleaning the pump, pay particular attention to the cleaning of the impeller unit and pump housing.
• Do not use aggressive cleaning agents or chemical solutions as they could attack the housing or impair the function
of the unit.
• Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent PumpClean from OASE.
– Vinegar- and chlorine-free household cleaning agent.
• Clean the outside of the pump.
– Use a soft brush as an aid.
– The formation of a thin layer of rust is normal and does not negatively affect the function.
• After cleaning, thoroughly rinse all parts in clean water.
Cause
No mains voltage
Excessively soiled water
The impeller unit is blocked
Impeller unit is running sluggishly
Excessive loss in the pipes due to friction
Excessively soiled water
Water temperature too high
The impeller unit is blocked
Pump has run dry.
Remedy
− Check the mains voltage.
− Check supply lines.
− Switching on the pump with Eco Control
− Clean the pump. The pump automatically
switches on again once the motor has
cooled down.
− Disconnect the power supply and remove
obstacle. Then switch the pump on again.
− Clean
− Select a larger pipe diameter.
− Reduce pipe length to the necessary mini-
mum.
− Avoid unnecessary bends and connection
elements.
− Clean the pump. The pump automatically
switches on again once the motor has
cooled down.
− Note maximum water temperature of
+35°C. The pump automatically switches
on again once the motor has cooled down.
− Disconnect the power supply and remove
obstacle. Then switch the pump on again.
− Flood the pump. Fully submerge the pump
for operation in the pond.
- EN -
27