Cleaning The Tank; Protecting The Environment - Black and Decker Powerful Solutions GSC500 Traducción De Las Instrucciones Originales

ENGLISH

Cleaning the tank

The appliance should be cleaned after use.
Remove the power head (8).
u
If there is any liquid left, drain the liquid back into the
u
original container or store in an appropriate container.
Fill the tank (9) to 1/3 of its volume with clean water and
u
soap.
Warning! Do not use flammable liquids for cleaning.
Replace the power head (8).
u
Spray the contents of the tank until the tank (9) is empty.
u
Repeat the previous instruction as many times as required.
u
Cleaning the filter (fig. D1)
If the stream of the liquid weakens the filter can be clogged.
To clean the filter proceed as follow:
Unscrew the tank cap (5).
u
Remove the suction tube (6) from the tank (9).
u
Clean the filter with warm soapy water.
u
Storing (fig. G & H)
Warning! Do not store in locations where the temperature is
below 0 °C.
Clean and dry all parts of the appliance when not in use
u
for more than one day.
Attach the wand handle (4) onto the side clips (22) (fig. G).
u
Fit the hose (23) with the Velcro fastener (24) to the power
u
head (8) (fig. H).
Accessories
The performance of your tool depends on the accessory used.
Black & Decker and Piranha accessories are engineered to
high quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your tool.
Troubleshooting
If the tool does not operate correctly, check the following.
Fault Possible cause
The stream of liquid Filter clogged.
weakens or stops.
Weak battery.
Suction tube not
all the way down
in the tank.
The unit will Battery not charged. Check the battery
not start.
10
Action
Check the filter at the end
of the suction tube.
Clean the filter with warm
soapy water.
Recharge the battery.
Push the suction tube
completely down.
charging requirements.

Protecting the environment

Z
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
z available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for
raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of our
after-sales service and contacts are available on the Internet
at: www.2helpU.com
Battery (fig. I & J)
Z
Black & Decker batteries can be recharged many times. If you
want to dispose of the product yourself, the battery must be
removed as described below and disposed of in accordance
with local regulations.
Warning!
Disconnect the appliance from the power supply before
u
removing the battery.
Do not short-circuit the battery terminals.
u
Do not dispose of the battery in fire as this may result in
u
an explosion.
Preferably discharge the battery by operating the
u
appliance until the motor stops.
Remove the power head (8).
u
Remove the screws (25) from the bottom (fig. I).
u