Optional Accessories; Protecting The Environment - DeWalt DCS551 Traducido De Las Instrucciones Originales

ENGLISH
2. Before hanging the sheet covering the outlet,
mark the approximate location of the centre of
the outlet on the wall board. Check the cutting
bit depth against the side of the board to be
sure it will cut entirely through the material.
3. Tack the sheet in place with a few fasteners
avoiding the stud holding the outlet. This
allows the wall board to flex slightly around the
protruding fixture box.
4. Turn the cut-out tool on. Holding the tool firmly
with both hands, plunge the bit straight into the
centre of the outlet.
5. Cut to the right until the edge of the box is
touched. Pull out just enough for the bit to clear
the edge of the box. Plunge in again holding the
bit gently against the outside of the box.
6. Follow the outside of the box as shown
keeping slight pressure against the box. This
will minimise wandering and give you a clean
precise cut.
7. Remove the waste and dust from the outlet.
Finish fastening the sheet of wall board.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
34
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
WALT, have
E
WALT product
E