Tabla de contenido
mecablitz and camera functions
Funzioni del mecablitz e della camera
mecablitz y funciones de la cámara
f t
Fig. 19 / Grabado 19
m
Fig. 20 / Grabado 20
TTL
mm
Auto Zoom
TTL
mm
Auto Zoom
Example:
In this example the maximum flash range extends
from 0.6 m to 6.2 m. Ideally, the subject should
be located within a distance range of approx. 2.5
m and 4.3 m.
5.4.2 Maximum flash range indication in
the manual flash modes M and MLo
The mecablitz LC display indicates the distance to
be maintained for correct exposure of the subject.
Adaptation to the given photographic situation is
achieved by changing the aperture setting on the
lens and selecting either „M" for full light output
or „MLo" for partial light output (see 4.2).
Example:
This example shows that the principal subject
should be at a distance of 6.2 m from the meca-
blitz.
5.4.3 Exceeding the display range (Fig. 19)
The mecablitz can indicate a maximum range of
199 m or 199 ft. This display range can be
exceeded in the event of high ISO values (e.g.
ISO 6400) and large aperture openings. An
arrow or triangle after the distance value in-
dicates that the display range has been exceeded.
5.4.4 Blanking out the maximum flash ran-
ge display (Fig. 20)
The mecablitz LC display does not indicate any
distances when the reflector head is swivelled up
or down out of its normal position!
5.4.5 Meter-Feet changeover (m - ft)
The maximum flash range indicated by the meca-
blitz LC display can be either in meter (m) or feet
(ft). To change between the two, proceed in the
following manner:
• Turn off the mecablitz by its main switch.
• Keep the „Select" key combination depressed (=
„Mode" key + „Zoom" key).
• Turn on the mecablitz by its main switch.
• Release the „Select" key combination (=
„Mode" key + „Zoom" key).
• The flash range indication changes from m to ft
or from ft to m.
5.5 LC display illumination
Keep the „Mode" or „Zoom" key depressed for
40
Tabla de contenido
