Manual Flash Mode; Manual Flash Mode M With Full Light Output; Manual Flash Mode Mlo With Partial Light Output - Metz MECABLITZ 44 AF-3 C Manual De Instrucciones

Tabla de contenido
Funcionamente del flash TTL
M
m
1
Fig. 10 / Grabado 10
M
Lo
m
2
Fig. 11 / Grabado 11
TTL-flash mode
Modo flash TTL
mm
Auto Zoom
mm
Auto Zoom

4.2 Manual flash mode

Some cameras automatically change the
mecablitz to TTL flash mode when in „green
full auto mode" or in one of the „programmed
image control modes". Manual flash mode is
then no longer possible. There is no correct
exposure confirmation on the mecablitz LC
display when in manual flash mode!
Set „Av" aperture priority or the „M" or „X"
manual modes on the camera. Select the aperture
and shutter speed (with „M") on the camera
according to the given photographic situation (see
the camera's operating instructions).
4.2.1 Manual flash mode M with full light
output (Fig. 10)
In this mode the mecablitz always fires uncontrol-
led flashes at full light output. Adaptation to the
given photographic situation is only by adjusting
the aperture setting on the camera accordingly.
The mecablitz LC display will indicate the flash-to-
subject distance that has to be maintained for a
correct exposure (see also 5.4.2).
Setting procedure for the manual flash mode M
• Turn on the mecablitz by its main switch.
1
Continue depressing the „Mode" key until „M"
flashes on the LC display.
• The setting becomes immediately effective. The
LC display is returned to its normal state after
approx. 5 sec.
4.2.2 Manual flash mode MLo with partial
light output (Fig. 11)
In this mode the flash unit always fires uncontrol-
led flashes at 1/8th (Low) of full light output.
Adaptation to the photographic situation is by se-
lecting a corresponding aperture setting on the
camera. The mecablitz LC display will indicate the
flash-to-subject distance that must be maintained
for correct exposure (see also 5.4.2).
Setting procedure for the manual flash mode
MLo
• Turn on the mecablitz by its main switch.
Continue depressing the „Mode" key until
2
„MLo" flashes on the LC display.
• The setting becomes immediately effective. The
LC display is returned to its normal state after
approx. 5 sec.
26
Tabla de contenido
loading

Tabla de contenido