Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Intelligent Networking & Internet Solutions
www.ansel.com.mx
Configuring the TCP/IP Protocol
1
On the Network dialog box Configuration card, select TCP/IP and then click Properties." The TCP/IP Properties dialog box will open.
2
On the IP Address tab, Change the IP address to 192.168.1.2(2~254 is ok) the subnet mask to 255.255.255.0, the gateway and the preferred
DNS server to 192.168.1.1 click OK. A dialog box will pop up asking you to restart the PC. Click Yes".
Checking TCP/IP settings
1. After completing the previous steps, click Start -> Run -> and type ipconfig /all. The IP Configuration window will open. If the PC does not show an IP
address in the 192.168.1.2 to 192.168.1.254 range, click the ipconfig /release button to release the current configuration. Wait a few seconds and click
"ipconfig/renew" to get a new IP configuration from the router.
2. If the IP configuration is correct, you will be able to use the PING diagnostic utility built into Microsoft Windows to ping the router. Click Start ->
Programs -> MS-DOS Prompt. A command mode window will open.Type "ping 192.168.1.1" (default IP of the router) to check the network connectivity.
If both hardware and software are correct, your computer will receive a response from the router as shown on the next page. If not, verify that the
Ethernet cable is connected to the router properly and the Ethernet port LED on the front panel is lit.
50
Capítulos
Tabla de contenido
