Rear Panel Descriptions; Features And Specifications - Ansel 7005 Manual Del Usuario

OFF
Line ON
Flashing
OFF
Phone ON
Flashing
OFF
GSM On GSM Network is found and working properly Flashing Searching GSM Network
SMS ON Short message waiting Indicator Flashing Sending short message

1.4.3 Rear Panel Descriptions

Port Description
Phone Phone port can be connected to analog telephone sets or Trunk Line of PBX
Line Can be Connected to PBX or CO line with RJ-11 analog line. PSTN not FXO port, can't connect PSTN to VoIP,. When PSTN
call comes, it will transfer to FXS port, let FXS can pick up call from VoIP or PSTN.
GSM The port which you can Insert SIM Card
Antenna Connect the antenna to the gateway. Connector
WAN Connect to the network with an Ethernet cable. This port allows your ATA to be connected to an Internet Access device, e.g.
router, cable modem, ADSL modem, through a networking cable with RJ-45 connectors used on 10BaseT and 100BaseTX
networks.
Reset Push this button until 3 seconds, and ATA will be set to factory default configuration.
1.5 Features & General Specifications
ANSEL MODELO 7005 Common Features and Specifications
Features
Waiting for network connection
Line is busy
Ring Indication
Line is not enabled
Telephone Set is Off-Hook
Ring Indication
Telephone Set is On-Hook
Power A power supply cable is inserted
Intelligent Networking & Internet Solutions
www.ansel.com.mx
45