Ansel 7005 Manual Del Usuario página 48

2 Change the IP address to 192.168.1.2(2~254 is ok)
3 Change the subnet mask to 255.255.255.0
4 Change the gateway and the preferred DNS server to 192.168.1.1
IP configurations above please refer to page 15
3. After Network Configuration is done. Connecting to an External Ethernet Hub or Switch:
1 Connect the Ethernet cable (with RJ-45 connector) to WAN port.
2 Connect the other end of the Ethernet cable to DSL/Cable modem or the external
Ethernet hub or switch.
[Notice: If It's not able to access the GSM Gateway via Internet
Please follow step.2 to enter gateway, the values are special premade settings
Port Description
Phone Line
SIM Antenna Connector
WAN
RES
AC power(DC in 12V) A power supply cable is inserted
The hardware installation is now complete. The following sections will guide you through setting up your management PC and connecting to the
Web User Interface.
FXS port can be connected to analog telephone sets or Trunk Line of PBX. Line
is used to connect to a PSTN line of carrier.
After Inserting SIM card ,the gateway is able to work as a mobile phone. Connect
the antenna to the connector
For Setting Connect directly to your PC with RJ 45
For WAN Connect to the network with an Ethernet
cable. This port allows your GW to be connected to an
Internet Access device, e.g. router, cable modem, ADSL
modem, through a networking cable with RJ-45
connectors used on 10BaseT and 100BaseTX networks.
Push this button until 3 seconds, and GW will be set to
factory default configuration.
Intelligent Networking & Internet Solutions
www.ansel.com.mx
48