DENTSPLY Sani-Tip Manual Del Usuario página 3

ADAPTER INSTALLATION INSTRUCTIONS
1
2
3
USER INSTRUCTIONS
1. Remove existing
thumb nut and syringe
tip. If nut, tip and
adapter unscrew
together, skip step
2. (If syringe has
nonremovable
thumb nut, refer to
Troubleshooting
section.)
2. Use enclosed hex key,
or appropriate tool
to remove existing
adapter from syringe.
3. Verify new adapter
has o-rings and
o p
position as shown.
1
1. With thumb nut loosened, insert new Sani-Tip disposable tip and
push into adapter as far as possible. While still pushing inward, twist
tip 1/2 turn clockwise to create a watertight seal over internal tapered
water spindle.
2 2. Hand tighten thumb nut. To redirect tip, push in on tip while rotating
clockwise.
TEST PRIOR TO EACH USE: Express water, then express air only.
If air contains moisture, or tip dislodges, refer to Troubleshooting
section.
3. To replace tip, loosen thumb nut. Remove and discard used tip.
Repeat steps 1 and 2.
n
in
4
4. Hand-thread adapter
into syringe. Use
hex key provided to
tighten.
5 5. Verify o-ring
m
in place inside large
opening of white plastic
cone .
l
6
6. With o-ring in place,
firmly snap large end of
white plastic cone over
adapter rim.
7
7. Hand-thread thumb
nut onto adapter. Do not
tighten until new tip has
been inserted.
Installation is complete.
is
3