Checking Tie Advancer; Replacing Tie Advancer - HellermannTyton AT2000 CPK Manual Del Usuario

10.5.3 Checking front cap and position of cutter
f Switch the power pack OFF.
1
4
f Remove screws
.
3
f Slacken screws
.
1
CAUTION
Cut hazard. The cutter is extremely sharp.
f Never touch the cutting edge with your ingers.
f Carefully remove front cap
f Remove tail cutter
.
2
f If necessary, replace tail cutter
f Remove cable-tie residues.
f Use compressed air to blow the tension gear and the
waste channel clean.
f Insert tail cutter
into the recess with the cutting
2
edge facing in.
f Insert front cap
with the lower jaw.
5
f Tighten screws
.
1
f Insert screws
and tighten.
3

10.5.4 Checking tie advancer

f Switch the power pack OFF.
1
f Push actuator for bandoleer cutter
f Press catch
.
3
f Open gate
.
1
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
2
3
with the lower jaw.
4
.
2
2
3
to the left.
2

10.5.5 Replacing tie advancer

f Remove screw
.
4
f Swing roller block
up.
5
f Replace faulty tie advancer
; The teeth of the tie advancer face down.
The tie advancer can be inserted in both directions.
1
f Push in the tie advancer as far as mark
A Position of tie advancer message appears if
positioning is not correct, à "Display messages" on
page 25.
f Close roller block
.
5
f Tighten screw
.
4
f Close gate
.
1
Maintenance
4
5
6
.
6
4
5
6
.
6
31