Measurement Environment Menu; Using Measurement Mode; Force Level - HellermannTyton AT2000 CPK Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 149
8.7

Measurement environment menu

The
Measurement environment
user has logged on with the setup specialist's password.
1
4
1 Show binding information
2 Show binding parameter settings
3 Status des AT2000 CPK
4 measurement results
5 List of measurement results
In measurement mode, the binding information for a
binding cycle with a measured force are documented in
a log ile. This ile can be used for the purposes of
monitoring tool performance.
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
menu appears only if the
2
5

8.7.1 Using measurement mode

The measurement mode is dependent on the
measurement process.
No cycle movement or jaw movement takes place while
measurement mode is active. Only the tensioning drive is
active, with the current binding parameter settings.
f Depending on the measurement process, activate the
measurement mode.
f Select the settings for the
parameters.
f Perform one binding.
; The binding information appears in the left pane of the
window.
f Enter the calculated force in the ield on the right.
f Click on Accept.
; A new line is added to the logile.
f Repeat the measurement procedure several times.
HT Data Management
3

Force level

and
Quality
22
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

106-00000

Tabla de contenido