Transport, Disposal And Storage; Disposal; Storage; Installation - HellermannTyton AT2000 CPK Manual Del Usuario

4

Transport, disposal and storage

4.1 Transporting the device
f Always use the case that comes with the device to
transport the AT2000 CPK.
4.2

Disposal

End-of-life (EOL) disposal of the device and individual
subassemblies and the disposal of consumables and
auxiliaries are subject in part to statutory regulations.
Detailed information is available on request from the
appropriate authorities (e.g. regional or national water
boards or environmental authorities).
f Dispose of packaging materials.
Always dispose of packaging materials in accordance with
the currently valid materials-disposal and environmental
protection regulations.
f Always take materials for disposal to certiied collection
points.
f Contact the manufacturer if there is any uncertainty
regarding disposal.
4.3

Storage

f Store the tool and the power pack in a cool, dry place.
f Avoid direct sunlight.
f Store the tool and the power pack in dustproof
packaging.
f Store electrical components (tool and power pack) in
impact-absorbing packaging and separately from the
accessories.
f Consult and comply with the appropriate data sheets for
storage of the accessories.
5

Installation

5.1 Installing the accessories
f Always proceed in accordance with the instructions
supplied with the accessory in question.
5.2

Connecting the device

1
f Connect power pack
2
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
2
In :
La
st Ti e
O ut
: Er
ro r
O ut
: Bu
sy
Se
ri al
po
rt
to power-supply outlet .
1
Transport, disposal and storage
3
2
f Use connecting cord
to connect the power pack to
2
toolAT2000 CPK .
3
6

Operation

6.1 Switching on
f The power-supply outlet must be readily accessible so
that the system can be de-energised if the need arises.
f Keep the main switch OFF when the AT2000 CPK is not
in use and when a change is to be made.
f Switch the power pack ON at the main switch.
; The
Signal and Power LEDs on the power pack show
green.
; The
Status LED on the AT2000 CPKshows green.
; The welcome screen appears on the display:
Autotool 2000 CPK
; The device is ready for use.
6.2

Switching off

f Switch the power pack OFF at the main switch.
6.3

Loading cable ties

1
3
f Insert cable tie bandoleer
; Make sure that cable-tie heads
f Press start trigger
.
3
P o
w e
r p
a c
k C
P K
D a
ta
S ig
n a
l
P o
w e
r
2
parallel with the drum.
1
are facing up.
2
11