Nice Neostar T Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 6

If you wish to cancel the FRT fabric tightening function, proceed as follows:
Table "A4" Erasing the "2" position (fig. 10)
Simultaneously press and hold down the ▲ and ▼ controls.
1.
2. Wait approximately 3 seconds for the awning to move briefly up.
Push the ▲ or ▼ button to move the awning to position 1.
3.
When the awning is in position 1 it automatically stops for an instant (0.2s); release the
button before the awning starts again.
Simultaneously press and hold down the ▲ and ▼ controls.
4.
5. Wait approximately 3 seconds for the awning to move briefly up.
Release the ▲ and ▼ controls.
6.
Note: If position "2" is cancelled, the awning will move between positions "0" and "1" that remain memorised.
If you wish to program positions "0", "A" and "S" to automate an awning with automatic hooking, proceed as follows:
Table "A5" Programming for awnings with automatic hooking (fig. 11)
Press and hold down the ▲ control to raise the awning.
1.
2. Wait for the motor to stop so that the awning is fully rolled up (position "0").
If you don't wish to program the RDC function, release the ▲ button and go to point 6;
3.
otherwise with the raise control button ▲ pushed, push the lower control button ▼ as well.
4. Wait for the awning to move briefly down.
Release the ▲ and ▼ controls.
5.
Press and hold down the ▼ control to lower the awning.
6.
Release the ▼ control when the awning is a few centimetres after the hooking point "A".
7.
If necessary use the ▲ and ▼ controls again and again until the correct position is reached.
Simultaneously press and hold down the ▲ and ▼ controls.
8.
9. Wait approximately 3 seconds for the awning to move briefly up and down and then stop
again in the position you have just programmed.
Release the ▲ and ▼ controls.
10.
Simultaneously press and hold down the ▲ and ▼ controls.
11.
12. Wait approximately 3 seconds for the awning to move briefly up.
Use the ▲ and ▼ controls until the awning has reached the release position "S".
13.
Simultaneously press and hold down the ▲ and ▼ controls.
14.
15. Wait approximately 3 seconds for the awning to move briefly up.
Do not release the buttons.
With the raise control ▲ and lower control ▼ pushed, wait another 3 seconds for the
16.
awning to perform a short lowering movement into the position that has just been memorised.
Release the ▲ and ▼ controls.
17.
6
Example
3s
Short stop
3s
Example
3s
3s