Connecting Inverter Cables; Important - Schumacher Electric PID-200-USB Manual Del Propietário

designed to automatically shut down. This safety feature
prevents damaging the inverter while testing devices and
equipment within the wattage range of the inverter.
If a device does not operate properly when first con-
nected to the inverter, turn the inverter rocker switch ON
(I), OFF (O), and ON (I) again in quick succession. If this
procedure is not successful, it is likely that the inverter
does not have the required capacity to operate the de-
vice in question.
4.

CONNECTING INVERTER CABLES

The inverter and power source must be in the OFF
mode.
IMPORTANT: Make sure you connect your inverter to a
12-volt power supply only.
INVERTER CONNECTION (Not necessary for model
PID-200-USB):
NOTE: For model PID-500-USB, determine whether you
will be using the battery clamps (500 watt output maxi-
mum) or the 12V accessory plug (120 watts maximum).
1. Locate the positive and negative plastic terminals
located on the right side of the inverter and remove
the terminal caps completely.
2. Install the positive (red) cable ring lug onto the posi-
tive (red) terminal screw. Install the negative (black)
cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot
come loose.
8 •
•