Memory; Displaying Stored Results - Medisana MTP Pro Instrucciones De Manejo

Tensiómetro de antebrazo
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63

5 Memory

5.1
Recording
the results
5.2
Displaying
stored results
6. Instead of " 1 ", the display now shows " 2 " for the second measurement.
The second measurement proceeds in the same way as the first (see points
2 - 5).
7. Instead of " 2 ", the display now shows " 3 " for the third measurement.
The third measurement proceeds in the same way as the first (see points
2 - 4).
8. Once the 3MAM measurement has been taken, the sleeve suddenly
deflates and a longer beep sounds.
9. The measured values SYS, DIA and PUL are shown on the display, togeth-
er with the WHO blood pressure bar
beep sounds.
10. If the unit detects an arrhythmia during the measuring process, the arrhy-
thmia symbol
You may also hear 8 short beeps; these warn the user of an irregular
heartbeat.
11. If you do not press any buttons for approx. 1 minute, the device automat-
ically switches to standby mode.
NOTE
When the device is used, the errors Err 1, 2, 3, 5, 6 can occur in
the integrated circuit. Err 6 can only occur in 3MAM mode.
In 3MAM mode, errors Err 1, 2, 3, 5 do not cause the
measurement to be cancelled, unless they occur twice in
succession. The error display is always accompanied by 3 short
beeps.
This unit features 2 separate memories, each with a capacity of 99 memory
slots. Results are automatically stored in the memory selected by the user.
When the memory is full, the oldest reading is always the first to be deleted.
Press the MEMORY button
ments in the display have been shown, an average value of all the measure-
ments in the selected memory is displayed. This average is indicated by "
When the MEMORY button
(switching between systolic, diastolic, pulse and date/time) of the last
measurement stored are displayed. If this measurement was taken in the
3MAM procedure,
the measuring process, the arrhythmia symbol
not flashing.
Press the MEMORY button
readings.
If you do not press any buttons for approx. 1 minute, the device automatically
switches back to standby mode.
4 Operation / 5 Memory
display. At the same time, a longer
will flash eight times while the reading is displayed.
to display the stored readings. After all the seg-
is pressed again, the individual readings
is displayed. If an arrhythmia was detected during
again to move backwards through the stored
GB
".
will be displayed, but
23
Tabla de contenido
loading

Este manual también es adecuado para:

51090

Tabla de contenido