Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
Cable Reel Series 793
2
2.1
3
3.1
10
Safety
This document contains important information that is presented either as a
warning, caution or note. See the following examples:
WARNING!
Risk of personal injury.
Warnings indicate a potential hazard to the health and safety of personnel,
and how that hazard may be avoided.
CAUTION!
Risk of equipment damage.
Cautions indicate a potential hazard to the product but not to personnel, and
how that hazard may be avoided.
NOTE! Notes contain other information that is important for personnel.
General
•
In accordance with the European standard the incoming 3-phase supply
should be fitted with a hand operated approved switch that must be
mounted near the Cable Reel. Refer to local and national standards when
located outside of Europe.
•
The continuity of the protective current circuit should be checked before
the Cable Reel is used.
•
Check that the supply voltage and frequency correspond with the data
on the machine plate of the Cable Reel before connecting to the mains
supply.
•
The Cable Reel should be connected to earth by the electrician carrying
out the installation.
•
Work on the electrical equipment may only be carried out by a qualified
electrician.
•
All power conductors and earth conductors should be checked and if
necessary retightened a few months after commissioning to ensure good
contact.
•
Never carry out service work, electrical or mechanical, without
disconnecting the mains voltage using an approved switch. Lock the
switch if necessary.
•
Always replace damaged, worn or defective electrical components or
other parts with new original parts.
Description
Dimensions: see figure 1(A). For technical data, see also type label on the
product.
Technical data
Table 3-1: Technical data
Voltage
Current
230 V
16 Amp.
400 V
10 Amp.
Conductors
Cable length
3 x 2.5 mm2
18 m (59 ft), 25 m (82 ft)
5 x 2.5 mm2
15 m (49 ft), 22 m (72 ft)
Power *
3680 W
6900 W
Capítulos
Tabla de contenido
