Wittur WSG-S1.2 Manual De Instrucciones página 73

4 Mechanical installation
4.4.6
Assembly of the manual release (optional)
)
Note!
The manual release is installed when the spring−applied brake has been
mounted onto the end shield (see chapters 4.3.1 ... 4.3.4). The air gap of the
brake is adjusted to the rated air gap.
Fig. 12 Assembly of the manual release
12.1 Lever
12.4 Stud bolts
1. Insert four stud bolts (12.4) into the bore holes of the transport safety bolts which
have been removed and screw down tight using a screw driver.
2. Locate the levers (12.1) onto the brake (14).
3. Place four disc springs (12.6) each opposed to each other onto the four bushes (12.7)
and insert the bushes into the bore holes of the levers (12.1).
4. Screw self−locking nuts (12.8) onto the stud bolts and tighten until dimension "s" has
been adjusted.
12.6 Disc springs
12.7 Bushes
BFK464−XX−S−016.iso/dms
j | BA 14.0197 | 11/2010
BFK464−XX−S−009.iso/dms
12.8 Nuts
14 Brake
BFK464−XX−S−015.iso/dms
i
29