Mounting - Wittur WSG-S1.2 Manual De Instrucciones

4 Mechanical installation
4.3

Mounting

4.3.1 Important notes
Minimum requirements of the end shield:
| Material S235 JR , C15 or EN−GJL−250
– If different materials are used, contact INTORQ.
| Evenness
– < 0.1 mm
| Axial runout 0.10 mm,
| Roughness Rz 10 to Rz 16
The threaded holes must have the minimum thread depth, dimensions ^ 15.
|
| The end shield must be free of grease and oil.
| Minimum requirements of the motor shaft:
– The diameter of the shaft shoulder must not be bigger than the tooth root diameter
of the hub.
4.3.2 Preparation
1. Unpack spring−applied brake.
2. Check for completeness.
3. Check nameplate data, especially rated voltage.
j | BA 14.0197 | 11/2010
i
21