Display Indications - Alliance Laundry Systems HF18VCV Operación/Programación

Display Meaning
Program identification code (ROM). This
FC 5
is an example only.
Hold Wait...power has just been turned on.
Pay (flashes alternately with start price if
PAY/(price)*
"FLSH" SETUP option is enabled)
CY Cycle (followed by two-digit number)
tESt/CYC* Test cycle selected.
FAr Degrees Fahrenheit
CEL Degrees Celsius
Heat Auxiliary heat enabled.
noHt Auxiliary heat disabled.
FLSH Flashing vend price enabled.
nFLS Flashing vend price disabled.
Start amount—flashes briefly before
n
Strt/A t*
showing vend price in SETUP mode
Coin 1 value—flashes briefly before
Con1/deno*
showing value of coin 1 in SETUP mode
Coin 2 value—flashes briefly before
Con2/deno*
showing value of coin 2 in SETUP mode
PrE Prewash segment (1st of 8 segments)
UASH Wash segment (2nd of 8 segments)
FIL1 First fill (3rd of 8 segments)
FIL2 Second fill (4th of 8 segments)
FIL3 Third fill (5th of 8 segments)
FIL4 Fourth fill (6th of 8 segments)
FIL5 Fifth fill (7th of 8 segments)
FIL6 Sixth fill (8th of 8 segments)
AFIL Auxiliary fill
bFIL Warm fill (both hot and cold)
CFIL Cold fill
bLCH Add bleach
*Display indications separated by a slash represent an alternating display.
F232061

Display Indications

Display
HFIL
Lo
n
ed
HI
SUP0
SUP1
SUP2
SUP3
SUP5
SUP6
drAI/dISt*
drAI/For*
n
SPIn/tI E*
SdLY
STOP
donE
HI 1
HI 2
bAL/FAIL*
SHUT/door*
CANt/OPEN*
FILL/STOP*
FULL
dFLt
tSFL
Operation
Meaning
Hot fill
Low water level
Medium water level
High water level
No supplies
Supply 1
Supply 2
Supply 3
Supply 5 (Supply 1 and 2)
Supply 6 (Supply 2 and 3)
Distribution (load balancing before extract)
Drain step (low speed forward in test
cycle)
Reads "SPIn" for one second, then
n
"tI E" followed by time for spin.
Spin coast delay
Stop routine
Cycle and stop routine have ended.
Low spin in test cycle.
High spin in test cycle.
Balance routine failed during test cycle.
Door not properly closed.
Computer cannot unlock door after five
attempts.
Programmed water level not reached after
30 minutes.
The computer detects low water level or
higher when none should be present.
Drive fault detected.
Temperature sensor failure or temperature
out of range.
15