Alliance Laundry Systems HF18VCV Operación/Programación página 26

Programming
Cycle Programming
When modifying a cycle, a time must be
entered for each segment. To skip a segment
or spin, set the time to "00" and press the Start
key. The following table gives the time
parameters for each segment and spin, as well
as the allowable temperature range.
Time and Temperature Parameters
Function Minimum
Prewash 2 minutes
Wash 2 minutes
Fill 1 2 minutes
Fill 2 2 minutes
Fill 3 2 minutes
Fill 4 2 minutes
Fill 5 2 minutes
Fill 6 2 minutes
Intermediate Spin 30 seconds
Final Spin
Temperature 75°F (25°C)
Spin times in cycle segments 1–7
Note:
(Prewash–Fill 5) are entered in seconds
(30 to 240), and time for final spin in
segment 8 is entered in minutes (1 to 10).
1. Press the Up key until the computer
display shows the segment to be edited.
Press the Start key.
2. Use the Up or Down key to select the
desired segment time. Set this value to
zero to skip the segment. Press the
Start key.
24
(Continued)
Maximum
30 minutes
20 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
15 minutes
240 seconds
1 minute 10 minutes
200°F (93°C)
3. Use the Up or Down key to select the
desired fill temperature. See the following
table for fill options.
Fill Temperature Options
Display
CFIL
HFIL
bFIL
AFIL
*Controls filling via an extra fill valve for special
applications only. Do not program this option unless
machine is equipped with extra fill valve.
4. Press the Start key.
5. Use the Up or Down key to select the
desired fill level. See the table below.
Water Level Options
Display
LO
n
ed
HI
6. Press the Start key.
7. Use the Up or Down key to select the
desired supply option. See the table below.
If as supply 2 (SUP2) step is
Note:
programmed, the display will flash "bLCH"
(add bleach) while supply 2 is on when the
cycle is in operation.
Fill Type
Cold fill
Hot fill
Warm fill
Auxiliary fill*
Fill Level
Low Level
Medium Level
High Level
F232061