Dimplex DF2608-EU Manual Del Usuario página 10

Operation
position the unit is off.
Resetting the Temperature Cut-
off Switch
This unit is equipped with a ther-
mostat which controls the tem-
perature of the room by turning
the heater on and off. The heater
is protected with a safety device
to prevent overheating. Should
the heater overheat, an automatic
cut out will turn the heater off and
it will not come back on without
being reset. It can be reset by
switching the Main Switch to "O"
and waiting 5 minutes before
switching the unit back on.
CAUTION: If you need to con-
tinuously reset the heater, unplug
the unit and call customer service.
Please have your model and se-
rial number ready when calling.
!
NOTE: The heater may emit
a slight, harmless odor when first
used. This odor is a normal con-
dition caused by initial heating of
internal heater parts and will not
occur again.
Remote Control
The fireplace is supplied with an
integrated on/off
Where the maximum rage of use
is ~5m.
10
(Figure 5)
remote control.
WARNING: It takes time for
the receiver to respond to the
transimitter. Do not press the but-
tons more than once within two
seconds for correct operation.
!
NOTE: Ensure that the fire-
place 3 position switch is set to
the remote control setting (up
position) .
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace
Battery Replacement
To replace the battery:
1. Slide battery cover open
on the back of the remote
control.
2. Install AAA batteries into the
remote control.
3. Replace the battery cover.
Discard leaky batteries. Dispose
Figure 5
off.
www.dimplex.com