Settings - Teac NR-7CD Manual Del Usuario

1
Press the MENU button repeatedly to show the
setting items.
The menu items appear in the following order .
PCM D-FILTER
DSD D-FILTER
DIMMER
METER
AUTO POWER SAVE
Input source information display
2
Turn the SOURCE knob to change the setting
value.
o You can also use the up and down (k, j) buttons on the
remote control .
o The currently set value is shown on the display .
3
When you are done changing settings, press
the MENU button repeatedly to show the input
source again.
o If no operation occurs for about 10 seconds, the input source
will reappear .
PCM digital filter
This sets the type of digital filter used when converting PCM signals
from digital to analog .
o During MQA playback, SDLY SLOW will be used regardless of the
setting .
*PCM D-FILTER
> OFF
OFF
No digital filter is used .
FIR SHARP
An FIR filter with a steep roll-off is used to sharply cut signals out-
side the audio band .
FIR SLOW
An FIR filter with a slow roll-off is used to gently cut signals out-
side the audio band .
SDLY SHARP
A short delay filter with a steep roll-off is used to sharply cut sig-
nals outside the audio band .
SDLY SLOW
A short delay filter with a slow roll-off is used to gently cut signals
outside the audio band .
Note about the digital filter during PCM playback
FIR-type digital filters
This type of filter has an established reputation for sound quality
and features tonal quality with both dense, rich sound reverbera-
tions and crisp sound transients .
SDLY-type digital filters
This type of filter has no pre-echo in the impulse response and
features natural sound attack and reverberation for a tonal quality
that is close to the original .

Settings

EN
25