Additional Functions - Hughes & Kettner FSM-432 MKII MIDI Board Manual De Instrucciones

Assigning controller numbers
Assignin functions (controller numbers) to the two Control
inputs works as follows:
• Control 1:
To access the edit mode, press and hold the buttons
Tap and D simultaneously until the display shows the
controller number and the dot behind the second digit
starts flashing. You can now change the controller
numbers using the Up/Down buttons. Store the selected
controller number by pressing D. The dot stops flashing,
and the FSM-432 MK III returns to normal mode.
• Control 2:
Press and hold Tap and C until the display shows the
controller number and the dot behind the first digit starts
flashing, then release them. Change the controller number
analogue to the proceeding for Control 1. Store and exit
with button C.

4 Additional Functions

The FSM-432 MK III offers even more functions. If you
press and hold Tap in combination with one of the four
preset buttons, you can access the following features:
• TAP + A = Bank direct mode
• TAP + B = Changeover to Stompbox Mode without
using the mode switch. To return to the Preset Mode,
press and hold TAP + B again or switch the FSM-432
MK III off and then back on.
• TAP + C = Edit controller number for Control 2, see
chapter 3.3. Factory default is controller number 64
(Boost).
• TAP + D = Edit controller number for Control 1, see
chapter 2.6. Factory default is controller number 07
(Volume).
You can also access special functions by pressing certain
combinations of buttons on the FSM-432 MK III when you
switch on the amp:
• "Power On" + A = Change the MIDI channel of the FSM-
432 MK III with the Up and Down buttons. Store and
exit with button A.
• "Power On" + TAP + Up = Factory reset of the FSM-
432 MK III. Press and hold TAP and Up until the display
shows a double eight incl. decimal point. Then release
the buttons. The individual segments of the display will
flash consecutively to indicate the successful factory
reset. After this, the starting sequence (see chapter 1)
follows.
• "Power On" + TAP + Down = Special function for
troubleshooting. In case operating your pedal doesn't
effect any changes on the amp, this mode can be used
to test the two Control inputs' proper functioning. The
display shows the position of the pedal in the context of
its total control range in percent (0-99%). The LEDs light
up from left to right with an increasing value.
Technical Data
Controller inputs 1 and 2
Midi In
Midi Out
External power supply
(optional)
Dimensions
Weight
All trademarks mentioned are the property of the respective owners.
FSM-432 MK III
6.3 mm (1/4") stereo jack
5-pin MIDI connector
Phantom powered 7-pin MIDI
connector
AC or DC 9-15 V / min. 250 mA
460 x 134 x 70 mm
1,7 kg / 3,7 lbs.
5